Sooooo . . . you wrap the coiled tube around the bbl ??
I can understand what this would do for you. Just don't understand the " general concept". --- SAWMAN
The concept relative to a supressor makes sense. Turns in gas flow dynamics for tube increase the resistance and I assume can lower the velocity of the gas. At the moment that gas arrives at the bolt carrier its velocity and pressure will be less. The bullet will have had more time to travel. The increased volume of the gas in the tube might also lower the pressure that gets to the bolt; however, there still is a greater volume gas arriving that should insure an adequate longer period of push, but slower push to operate the bolt carrier group.Sooooo . . . you wrap the coiled tube around the bbl ??
I can understand what this would do for you. Just don't understand the " general concept". --- SAWMAN
See #11.
This is another route besides just restriction and moving more mass. Trying to increase the time before unlocking starts and decrease dwell time. Longer gas tube could sill be used in conjunction with an adjustable block/bcg depending on desired outcome. Heavier buffer is lower on my list of preferred fixes.
Here and done.
Gas tube - Pigtail Pistol Length Gas Tube Stainless steel + Steel gas block AR15 223 5.56
AR15 223 5.56AR M4 Pigtail Pistol Length Gas Tube Stainless Steel + Steel gas blockGas Tube Stainless Steel ConstructionComes with Roll PinPins into fro...www.ar15handguard.com