-
Please read the new forum rules! REQUIRED!
Click Here: https://www.gulfcoastgunforum.com/threads/general-forum-rules-code-of-conduct.70770/
-
New Reloading Sticky Thread for Trading, Swapping Gear, etc.
https://www.gulfcoastgunforum.com/threads/reloading-components-for-trade-item-value-and-photo.104847/
7.62x51
- Thread starter bostic8
- Start date
The #1 community for Gun Owners of the Gulf Coast States
Member Benefits:
Fewer Ads! Discuss all aspects of firearm ownership Discuss anti-gun legislation Buy, sell, and trade in the classified section Chat with Local gun shops, ranges, trainers & other businesses Discover free outdoor shooting areas View up to date on firearm-related events Share photos & video with other members ...and so much more!
Member Benefits:
Baddog 0302
Master
RULES, need a price
And is the "DAG93A0306" the head stamp ?
A nickle alloy bullet ,??
And is the "DAG93A0306" the head stamp ?
A nickle alloy bullet ,??
I had some of these silver 7.62 NATO bullets about ten years ago in a Mauser with a front sight too high. Didn't realize that I was shooting so low until the angle iron target stand fell over. I'd mowed the centered post under the target right in half. Oops... At least it was accurate. It did attract a magnet too. Found that out later after I was cleared to shoot it on an indoor range... I asked the front desk first... and that's the only reason I didn't have to pay for the damages to their backstop after nippling their hardened steel wall. They yelled cease fire and came around stall by stall with a magnet. It's loaded hot too. I wouldn't put it in an Ishapore Enfield ever again... after I blew a golf ball size chunk of wood stock out of the wrist on a relatively rare Ishapore. Man was I pissed. I paid to have it professionally repaired and then I pawned it. I let the pawn shop know too and I still got more than I paid for it! But I was just afraid to shoot it again. Got lucky I didn't have a splintered hand. This is good stuff to have around for penetration
Last edited:
