SOLD, GONE... S&W .357 mag Milton

[Yukon]

Price

$900

Item Location

Milton $900 obo

Mid 90s .357 in very nice condition. Everything pictured. 3 sets of grips .
Contact here via PM.
Prefer carry permit holders . This is not junk. Please offers of comparable value.

 

[FowlHunter13]

I am going to guess that to be either a model 19 nickel or a model 66 that someone put a lot of time on a buffing wheel.

 

[Yukon]

I am going to guess that to be either a model 19 nickel or a model 66 that someone put a lot of time on a buffing wheel.

I know model 66s only supposed to only be in stainless . However I don't see indication of being buffed finish?? Not sure. Beautiful looking and 100% on function/mechanical

 

[Jester896]

if it was buffed I don't see evidence on the lettering on this side in the pics...good work if it was

 

[BluesBrother]

If it were a 19 the hammer would be case colored. If it's stamped 66-4 it's stainless. I can't see Smith incorrectly stamping a frame. That luster without swirls can be achieved with Semichrome or Flitz or even Mothers and an old T shirt and time and patience.

 

[Yukon]

If it were a 19 the hammer would be case colored. If it's stamped 66-4 it's stainless. I can't see Smith incorrectly stamping a frame. That luster without swirls can be achieved with Semichrome or Flitz or even Mothers and an old T shirt and time and patience.

Well I much rather a stainless. With a darn fine polish job.. Mirror finish. Definitely a Model 66-4. Very light single action break typical of a few model 66s I owned. Had an early 70s model 19 and this has as fine as a mirror finish as that nickel plated.
Appreciate the info. Getting rusty .

 

[G-rat]

Pm'd you...

 

[flipparker]

PM sent

 

[ccc]

PM sent