Murfpcola
Master
I went to visit family in AL and decided to put a few rounds through a polymer 80 I had rearranged recently. This is built from a gen 3 Glock 17 that I had. I originally put the parts into a 17 size polymer80 frame and it seemed to work ok. Recently I took the parts out of that frame and put them into a 17 length frame with the 19 length grip. This frame had Glock 22 internals and slide and seemed to work fine. Today I only put five rounds through it but 3 of the shells I picked up had scuffs/dents. You can also see where the brass hit the slide. Any idea. What would cause this?
Again this is a p80 frame that takes the full-size slide and compact mags. All parts are factory Glock 17 from a complete pistol I stripped. The magazine was a Magpul 21 rounder that only has had about 50 rounds through it.
Again this is a p80 frame that takes the full-size slide and compact mags. All parts are factory Glock 17 from a complete pistol I stripped. The magazine was a Magpul 21 rounder that only has had about 50 rounds through it.