snakeoil1227
Shooter
I think I built a PA 9mm carbine,but it doesn't eject after the first two or three rnds...any gunsmiths in the Spanish fort,al. area? thanks for your help!
The 9mm is a blowback system right? No gas? Every psa ive had, had a gas block problem that was easily repaired.
Sent from my LM-G820 using Tapatalk
Does the casing stay in the chamber? Does is half eject? Stovepipe?So,can you tell me how to remedy the blow back problem? I am mechanically inclined,so I can take instructions, thanks for your help!
If it's a new build, try oiling the shit out of the firing pin and bolt. My brother had a new build that I believe just had too tight of machining tolerances and needed a little extra oil to break it in. After it was broken in, it functioned fine. If it's cycling a few rounds, and then stopping, check the primer on the third round for light primer strikes.