HD Tactical

Working A Little .308

The #1 community for Gun Owners of the Gulf Coast States

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!
  • Jester896

    Master
    GCGF Supporter
    Rating - 100%
    9   0   0
    Joined
    May 14, 2017
    Messages
    2,534
    Points
    113
    Location
    SW GA
    Anybody wanna help? Can't decide if I should anneal it first or after. Every bit of that is NATO RA 69 head stamped that I am almost certain is 1X fired...still has sealer around primer pockets. About to clean it a little and run it through the Dillon to size and trim it. 2 of the cans I brought back from my Road Trip had all of this neatly stacked inside.
    .308.jpg
     

    Attachments

    • .308.jpg
      .308.jpg
      72.6 KB · Views: 234

    Daezee

    Master
    Rating - 100%
    13   0   0
    Joined
    Dec 17, 2012
    Messages
    3,355
    Points
    113
    Location
    Milton
    I don't anneal "common" brass, not worth the effort in my opinion. When I used to reload 577/450 Martini Henry, I did anneal, as the brass was very expense (and I never lost a case from a neck split).
     

    Jester896

    Master
    GCGF Supporter
    Rating - 100%
    9   0   0
    Joined
    May 14, 2017
    Messages
    2,534
    Points
    113
    Location
    SW GA
    Your probably right...there is a Ken Light with a case feeder sitting right there...wouldn't be a lot of trouble...might even help clean it a little :)
     

    Jester896

    Master
    GCGF Supporter
    Rating - 100%
    9   0   0
    Joined
    May 14, 2017
    Messages
    2,534
    Points
    113
    Location
    SW GA
    this stuff is a little nicer than the LC I normally see...was looking inside cases today to see how much the swagger might close up the flash hole and the look like they were finished after they were stamped. I wonder if it is Remington Arms or Raufoss Ammunisjonsfabrikker :)
     
    Last edited:
    Top Bottom